Brady BP-PR PLUS Series Provozní pokyny stáhnout pdf (Strana 27)

BP-PR PLUS series

Cleaning and basic maintenance

Edition 7/06 Operating Instructions 27

8 Cleaning and basic maintenance

8.1 Maintenance plan

Tab. 8: Maintenance plan

8.2 Tools and cleaning agents

Cleaning agents

DANGER!

Risk of death via electric shock!

⇒ Disconnect the printer from the power supply before performing any maintenance work.

Maintenance task When

General cleaning (see ”8.3” on page 28) as necessary

Clean print roller (see ”8.4” on page 28) each time the label roll is changed or

when the print image and label trans-

port are adversely affected.

Clean printhead (see ”8.5” on page 28) direct thermal printing: each time the

label roll is changed

thermal transfer printing: each time

the transfer ribbon is changed

or when the print image is adversely

affected

Clean label sensor (see ”8.6” on page 29) when the label roll is changed

Replace printhead (see ”8.7” on page 30) when errors in the print image occur

Replace print roller and rewind assist roller

(see ”8.8” on page 32)

when print image and label transport

are adversely affected

For adjustments and simple installation work, use the accompanying hexagonal wrench located in the

bottom section of the print unit. See Fig. 5, Item 8. No other tools are required for the work described

here.

• soft brush

• roller cleaner

• soft cloth

• cotton swabs

• pure alcohol

• special cleaning pen

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 39 40

Žádné komentáře

Brady BP-PR PLUS Series Provozní pokyny Strana 27