Brady THT-BP Precision Specifikace stáhnout pdf (Strana 8)

8 THT-BP Precision

Loading Transfer Ribbon

Figure 5

CAUTION !

To avoid premature deterioration of the printhead, make sure the transfer

ribbon is slightly wider than the width of label backing.

NOTICE !

For direct thermal printing no transfer ribbon is needed !

1. Raise the printhead assembly (2) by rotating the lever (1) clockwise until it

stops.

2. Slide the roll of transfer ribbon (5) as far as possible onto the ribbon

supply hub (6).

3. Hold tight the supply roll (5) and rotate the knurled knob (7) counter-

clockwise to clamp the roll onto the ribbon supply hub (6).

4. Slide a cardboard core (3) onto the ribbon take up hub. Clamp the core by

rotating the knurled knob (4) counter-clockwise.

5. Feed the transfer ribbon along the path as shown in figure 5 and attach it

to the cardboard core (3) using a piece of tape or a label. In figure 5 the

solid line represents ribbon with ink on the inner side, and the broken line

represents ribbon with ink on the outer side.

6. Turn the ribbon take up hub counter-clockwise until the ribbon is taut and

without any wrinkles.

7. Lower the printhead by rotating the lever (1) counter-clockwise until it

locks.

764

3 5

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Žádné komentáře

Brady THT-BP Precision Specifikace Strana 8